Push-pull pot replacement
2 posters
Page 1 of 1
Push-pull pot replacement
All:
I have a '84 Spectrum in HSH configuration with three push-pull pots, (1) volume, (2) tone. All three are DPDT, the switches are (IIRC) coil-tap, phase, and center p/u enable.
I need to replace the volume pot, and I'm not sure where to go for a direct replacement. Any ideas for source, and/or a spec or part number? I love this guitar, but the erratic volume pot has reached the point that I can't gig with it until it's fixed.
Thanks in advance,
The Hack
I have a '84 Spectrum in HSH configuration with three push-pull pots, (1) volume, (2) tone. All three are DPDT, the switches are (IIRC) coil-tap, phase, and center p/u enable.
I need to replace the volume pot, and I'm not sure where to go for a direct replacement. Any ideas for source, and/or a spec or part number? I love this guitar, but the erratic volume pot has reached the point that I can't gig with it until it's fixed.
Thanks in advance,
The Hack
SteinbergerHack- Registered Member
- Number of posts : 8
Registration date : 2019-04-27
Re: Push-pull pot replacement
Are they metric or SAE? Long shaft or short?
SteinbergerHack- Registered Member
- Number of posts : 8
Registration date : 2019-04-27
Similar topics
» Push Pull pots, electronics install.
» Wiring Diagram for a Pantera X390 with single coil and phase reverse pull switches
» Replacement nut
» Possible FT bridge replacement??
» x390DBK wiring - w push button pickup selector
» Wiring Diagram for a Pantera X390 with single coil and phase reverse pull switches
» Replacement nut
» Possible FT bridge replacement??
» x390DBK wiring - w push button pickup selector
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|