The · W e s t o n e · Forums
Would you like to react to this message? Create an account in a few clicks or log in to continue.

Push-pull pot replacement

2 posters

Go down

Push-pull pot replacement Empty Push-pull pot replacement

Post by SteinbergerHack Thu Jan 02, 2020 11:10 am

All:

I have a '84 Spectrum in HSH configuration with three push-pull pots, (1) volume, (2) tone.  All three are DPDT, the switches are (IIRC) coil-tap, phase, and center p/u enable.

I need to replace the volume pot, and I'm not sure where to go for a direct replacement.  Any ideas for source, and/or a spec or part number?  I love this guitar, but the erratic volume pot has reached the point that I can't gig with it until it's fixed.

Thanks in advance,
The Hack
SteinbergerHack
SteinbergerHack
Registered Member

Number of posts : 8
Registration date : 2019-04-27

Back to top Go down

Push-pull pot replacement Empty Re: Push-pull pot replacement

Post by Westbone Sat Jan 04, 2020 6:53 am

Loads of those on Ebay etc.

Use an A 500k
link

  a n other link
Westbone
Westbone
Financial supporter

Number of posts : 5918
Location : Redbridge
Registration date : 2008-12-28

http://www.chruler.com/

Back to top Go down

Push-pull pot replacement Empty Re: Push-pull pot replacement

Post by SteinbergerHack Sat Jan 04, 2020 7:59 am

Are they metric or SAE?  Long shaft or short?
SteinbergerHack
SteinbergerHack
Registered Member

Number of posts : 8
Registration date : 2019-04-27

Back to top Go down

Push-pull pot replacement Empty Re: Push-pull pot replacement

Post by Westbone Sat Jan 04, 2020 9:54 am

Measure the ones you have.

All Westone gear is metric.
Westbone
Westbone
Financial supporter

Number of posts : 5918
Location : Redbridge
Registration date : 2008-12-28

http://www.chruler.com/

Back to top Go down

Push-pull pot replacement Empty Re: Push-pull pot replacement

Post by Sponsored content


Sponsored content


Back to top Go down

Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum