The · W e s t o n e · Forums
Would you like to react to this message? Create an account in a few clicks or log in to continue.

Spectrum SX Single Coil Replacement

+5
hendrik
corsair
Warrn
Barry
SunDog
9 posters

Go down

Spectrum SX Single Coil Replacement Empty Spectrum SX Single Coil Replacement

Post by SunDog Sun Feb 21, 2010 7:36 pm

The middle p/u on my SX is toast. I went to replace it yesterday - got way into the process and then realized that the cavity does not accept a std single coil shaped like the ones I had lying around. I would like to find an original Magnaflux replacement - so if anyone has one for sale - let me know. Barring that, any suggestions on pickups that will fit in the cavity.

Thanks in advance.
SunDog
SunDog
Westone Nut

Number of posts : 73
Registration date : 2010-01-29

Back to top Go down

Spectrum SX Single Coil Replacement Empty Re: Spectrum SX Single Coil Replacement

Post by Barry Sun Feb 21, 2010 8:25 pm

Sorry to hear that SunDog. Always painful when these vintage pups poop out.
Any chance of rewinding her (I'm assuming that's the problem)?
Might be the best solution in the long run.

_________________
"A little song. A little dance. A little seltzer down your pants." -Chuckles the Clown
Spectrum SX Single Coil Replacement Guitar10
GUITARS : https://legend.barryeames.com
MUSIC/PIX/VIDEOS: https://getback.barryeames.com (including Spectrum ST)
Barry
Barry
Hero, Legend, and all round good guy

Number of posts : 8789
Age : 79
Location : Port Weller, St. Catharines, Canada
Registration date : 2009-05-01

https://legend.barryeames.com

Back to top Go down

Spectrum SX Single Coil Replacement Empty Re: Spectrum SX Single Coil Replacement

Post by Warrn Sun Feb 21, 2010 9:02 pm

Rewinding might be the best solution. It's rare enough to see an MMK45 on eBay, but I've never seen one of the singles.
Warrn
Warrn
Moderator

Number of posts : 1133
Age : 36
Location : Gainesville, FL
Registration date : 2008-08-03

Back to top Go down

Spectrum SX Single Coil Replacement Empty Re: Spectrum SX Single Coil Replacement

Post by corsair Sun Feb 21, 2010 10:57 pm

yeah; I'm betting that the s/c were thrown over the left shoulder when they got replaced, sadly. Someone in here must have replaced one or two at some stage, surely??
avatar
corsair
Senior Member

Number of posts : 6352
Age : 65
Location : Mount Hunter, NSW, Australia
Registration date : 2008-04-08

Back to top Go down

Spectrum SX Single Coil Replacement Empty Re: Spectrum SX Single Coil Replacement

Post by hendrik Mon Feb 22, 2010 1:48 pm

I faced a similar problem with the middle pick-up on my green concord.

After a while I saw the broken bare wire. Just at the outside.
Soldered both end together, works fine now.

No idea it will help. But it's worth try.

H.
hendrik
hendrik
Senior Member

Number of posts : 195
Age : 58
Location : Switzerland
Registration date : 2008-11-03

Back to top Go down

Spectrum SX Single Coil Replacement Empty Re: Spectrum SX Single Coil Replacement

Post by boutjp97 Tue Feb 23, 2010 5:30 am

Find an old clunker Westone and part it out. We have used gear stores in the states and at this very moment this is for sale for $79.99 USD. Looks like a challenger which was Korean made but used some Matsumoku stock. The pickups are different but you get the idea. Just wait for one to come along.
Spectrum SX Single Coil Replacement 1YJVkaoMQ0KB8DfX1tmK-A
boutjp97
boutjp97
Senior Member

Number of posts : 306
Age : 51
Location : Boston, New York USA
Registration date : 2008-05-16

https://www.facebook.com/jason.bouton

Back to top Go down

Spectrum SX Single Coil Replacement Empty Re: Spectrum SX Single Coil Replacement

Post by Westbone Wed Feb 24, 2010 8:32 am

Hello, might have a pickup for you. Middle pickup has a blue live? reverse wound, reverse polarity. I have one reads 5.73. Cant recall which Spectrum it came off but is a middle pup. Give us a shout if it's any good to you.
Westbone
Westbone
Financial supporter

Number of posts : 5918
Location : Redbridge
Registration date : 2008-12-28

http://www.chruler.com/

Back to top Go down

Spectrum SX Single Coil Replacement Empty Re: Spectrum SX Single Coil Replacement

Post by SunDog Wed Feb 24, 2010 2:25 pm

That would be the one. Let me know what you would like for it

email johnnyo3478@gmail.com
SunDog
SunDog
Westone Nut

Number of posts : 73
Registration date : 2010-01-29

Back to top Go down

Spectrum SX Single Coil Replacement Empty Re: Spectrum SX Single Coil Replacement

Post by silence86 Wed Feb 24, 2010 5:13 pm

i would be interested in the broken one by the way Spectrum SX Single Coil Replacement Icon_wink ...i'd like to have a try in rewiring a pickup...
silence86
silence86
Senior Member

Number of posts : 502
Age : 38
Location : Kaiserslautern,Germany
Registration date : 2008-11-13

http://first-daze.de

Back to top Go down

Spectrum SX Single Coil Replacement Empty Re-string a Rail

Post by pfbacon Sat Feb 27, 2010 3:03 pm

Hi you guys,

Can you tell me how to put new strings on my rail bass? It's not made like any bass I've had before.

I would post a new thread about it but I can't find the post button on this website.

Thanks for helping a newcomer.

pfbacon pfbacon@gmail.com
avatar
pfbacon
Registered Member

Number of posts : 11
Registration date : 2010-02-27

Back to top Go down

Spectrum SX Single Coil Replacement Empty Re: Spectrum SX Single Coil Replacement

Post by Warrn Sat Feb 27, 2010 11:42 pm

Okay, on your Rail bass instead of a headstock with tuners, there is a clamp behind the nut, held down with three allen screws. once you have detuned the bass to loosen the strings, you need to pull the allen screws back enough to pull the strings out (taking the clamp all the way off is fine). Now take your new strings, insert the ball ends into the tuning block past the bridge, and slip the ends of the strings through the holes behind the clamp; clamp them, cut them off, tune. Cut the strings off as close as you can; they will be sharp. If you mark where they come out from the back of the bass, pull them out, and then cut them off so they aren't sticking out at all, all the better.
Warrn
Warrn
Moderator

Number of posts : 1133
Age : 36
Location : Gainesville, FL
Registration date : 2008-08-03

Back to top Go down

Spectrum SX Single Coil Replacement Empty Thanks!

Post by pfbacon Sun Feb 28, 2010 12:02 am

Thank You!
I will try it.
pfbacon
avatar
pfbacon
Registered Member

Number of posts : 11
Registration date : 2010-02-27

Back to top Go down

Spectrum SX Single Coil Replacement Empty Success

Post by pfbacon Sun Feb 28, 2010 5:08 pm

I got the strings changed, thanks again for your advice.

I also had to take off the plate over the tailpiece to get the ball ends out of (and new ball ends into) their little cavities.
I could have used an extra hand - the ends kept jumping out as I put the next ends in.

Changing strings on the Rail is a pretty big hassle but being a bass player I won't have to do this often.
If I was a guitarist breaking strings every night I would throw a matching pair of middle fingers at westone.

I used LaBella black tape wound strings. If there is a way to post an mp3 here I will put up a clip soon.
If not, I will put something up on my myspace (Peggy Foster Bassplayer).

Now I'm wondering if there's a way to adjust the height of the strings over the pick-up, just in case they need to be evened out.

Peggy Foster Bassplayer
avatar
pfbacon
Registered Member

Number of posts : 11
Registration date : 2010-02-27

Back to top Go down

Spectrum SX Single Coil Replacement Empty Re: Spectrum SX Single Coil Replacement

Post by Warrn Sun Feb 28, 2010 11:20 pm

You can move the pickup up or down on each side.
Warrn
Warrn
Moderator

Number of posts : 1133
Age : 36
Location : Gainesville, FL
Registration date : 2008-08-03

Back to top Go down

Spectrum SX Single Coil Replacement Empty Yes, I know ...

Post by pfbacon Mon Mar 01, 2010 4:47 pm

Loosening the knob and sliding the pick-up up and down changes the tone on all the strings,
but it doesn't change how close each string is to the pick-up.
On most basses, we can adjust each string closer or further from the pick-up by turning tiny screws on the bridge, raising and lowering each string to compensate for varying thicknesses of strings from one brand to another.
Perhaps Westone doesn't have that, I don't see it readily.
When I was recording with the Westone, one string got picked up louder than the others and the A string was quieter than the others ... doesn't happen when I record with my other basses so it's not a finger technique problem or a recording device problem.
I wondered if the Westone needed new strings so I changed them.
I'll record with it tomorrow and see how it goes.
Thanks! Peggy
avatar
pfbacon
Registered Member

Number of posts : 11
Registration date : 2010-02-27

Back to top Go down

Spectrum SX Single Coil Replacement Empty Re: Spectrum SX Single Coil Replacement

Post by Warrn Mon Mar 01, 2010 5:19 pm

You're talking about adjusting the action with the bridge saddles, and yes it can be done, you just need a small allen wrench. You can also adjust the position of the pickup itself with a small screwdriver, the middle screw of the three screws on the left or right of the pickup will raise or lower it (unless you have an aftermarket pickup).
Warrn
Warrn
Moderator

Number of posts : 1133
Age : 36
Location : Gainesville, FL
Registration date : 2008-08-03

Back to top Go down

Spectrum SX Single Coil Replacement Empty Cool!

Post by pfbacon Wed Mar 03, 2010 9:34 pm

I'll try your suggestions ... Thanks!

Peggy
avatar
pfbacon
Registered Member

Number of posts : 11
Registration date : 2010-02-27

Back to top Go down

Spectrum SX Single Coil Replacement Empty Re: Spectrum SX Single Coil Replacement

Post by Sponsored content


Sponsored content


Back to top Go down

Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum