neck dimension question
Page 1 of 1
neck dimension question
Would a Thunder bolt on neck fit in a pantera 300?
I have a strange project in mind where I'm looking to put a neck on an x300 that has the 3x3 tuner setup. I like the Thunder headstock, but have no access to see if they are compatible as a swap for the 300.
I have a strange project in mind where I'm looking to put a neck on an x300 that has the 3x3 tuner setup. I like the Thunder headstock, but have no access to see if they are compatible as a swap for the 300.
Guest- Guest
Re: neck dimension question
If the neck did fit, It would not work as the Pantera 300 is 25 1/2 inch scale and the Thunder is 24 3/4 inch scale (the bolt on version anyway)
bowenjaybee- Senior Member
- Number of posts : 560
Age : 51
Location : Bradford, West Yorkshire . UK
Registration date : 2010-02-22
Re: neck dimension question
I'm not too worries about the scale as this project means getting rid of the trem and putting a fixed bridge on, so I can adjust as needed.
Just looking to see if a 3x3 neck that exisits that would fit a x300 neck pocket.
Just looking to see if a 3x3 neck that exisits that would fit a x300 neck pocket.
Guest- Guest
Similar topics
» Pickup question ...
» anyone know the neck heel specs of westone spectrum ST bass? (what can I replace the neck with?)
» Question about my Concord III
» New Bridge & Neck on Westone Spectrum DX - Advice Needed on Neck and Bridge Replacement
» x390 on eBay
» anyone know the neck heel specs of westone spectrum ST bass? (what can I replace the neck with?)
» Question about my Concord III
» New Bridge & Neck on Westone Spectrum DX - Advice Needed on Neck and Bridge Replacement
» x390 on eBay
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|