Humbucker mounting issue

Bought a Suhr SSH+ to try in my Dynasty.  Slight problem.  The humbucker mounting holes had been drilled out for a direct mount application.  Therefore the height adjustment/mounting screws won't work (holes are too big and not threaded).  See what I mean in this photo:



Any ideas on how to amend this?  The seller recommended masking tape about 4x around each hole and then drilling through the tape.  Says it works very well.  Let me know what you think.

I'm thinking to super glue a small nut over each hole (a nut that fits the mounting screw).  That would work.

Solder a nut on.

I'll go nut shopping soon and make that happen.

The Chad wrote:I'll go nut shopping soon and make that happen.

That's what she said.  

(You knew it was coming)

........and she found you......... ......

Lucky woman!

   You guys are a trip!  Can always count on the forum guys for some entertainment!

We're here all week folks.
Try the veal, and don't forget to tip yer waitress.

  

I usually say "I'm here till Thursday... the real talent comes for the weekend."

Just an update, I had soldered my nuts on and it worked great.  Gotta watch your heat so you don't get all the wax melting out.  I had two alligator clips on each side of the pickup ear, they were my heat sinks. 

So if you have pickups intended for direct mount, just find some nuts and solder them on.

Great tip Damian. Well done Chad!