Broken off bridge mount screw...
5 posters
Page 1 of 1
Broken off bridge mount screw...
Would appreciate advice/suggestions as to what to do with a broken off bridge mounting screw. Other four screws are fine and bridge seems solidly mounted. Doesn't seem to affect sound or ground. Leave as is, try to drill out.....any opinions would be greatly appreciated.
Sodbuster J- Westone Nut
- Number of posts : 53
Age : 57
Location : NE Wisconsin
Registration date : 2012-10-03
Re: Broken off bridge mount screw...
You could try drilling it out with with a screw remover. It is like a drill bit but the tread is reversed and you have to operate the drill in reverse
Newbie1- Registered Member
- Number of posts : 16
Location : Wellington
Registration date : 2013-05-19
Re: Broken off bridge mount screw...
If its causing no issues, let it be. It's only going to be a problem if it comes to mounting a new bridge.
Otherwise, yeah: screw removers or I've had to drill out around the shank of the screw to get a decent grip on it to get it out and then fill the resulting hole with polyester padding, or a piece of dowel - the method of filling will depend on the guitars finish! - but it's easy enough to do; normal rules apply....
Think it through and take it easy!
Otherwise, yeah: screw removers or I've had to drill out around the shank of the screw to get a decent grip on it to get it out and then fill the resulting hole with polyester padding, or a piece of dowel - the method of filling will depend on the guitars finish! - but it's easy enough to do; normal rules apply....
Think it through and take it easy!
corsair- Senior Member
- Number of posts : 6333
Age : 65
Location : Mount Hunter, NSW, Australia
Registration date : 2008-04-08
Re: Broken off bridge mount screw...
If there is enough of the screw showing, you could dremel cut a slot for a flathead screwdriver.......it works if the slot is thin enough.
Sgt. Vimes- Financial supporter
- Number of posts : 3322
Age : 53
Location : tyneside
Registration date : 2011-11-03
Re: Broken off bridge mount screw...
Leave as is and superglue the head to the bridge.
Isn't going to make much or any difference as you say.
Which guitar is it anyway?
Isn't going to make much or any difference as you say.
Which guitar is it anyway?
Re: Broken off bridge mount screw...
Thanks for the advice/opinions fellas...I purchased the guitar off eBay, and unfortunately it came to me with the screw head busted off. It's a Ray bridge from the APII Thor Sound 400 I recently purchased. It doesn't seem to be a problem so I think I will leave it be. It's under one of the saddles and I didn't even notice it myself till I changed the strings. Thanks again!
Sodbuster J- Westone Nut
- Number of posts : 53
Age : 57
Location : NE Wisconsin
Registration date : 2012-10-03
Similar topics
» Repairing a Bendmaster locking nut with Helicoils
» Spectrum V Bass Bridge Saddle Adjustment Screw Alternatives?
» Broken Coil MMK 45
» New Bridge & Neck on Westone Spectrum DX - Advice Needed on Neck and Bridge Replacement
» ...and the Genesis I that became a project as well.
» Spectrum V Bass Bridge Saddle Adjustment Screw Alternatives?
» Broken Coil MMK 45
» New Bridge & Neck on Westone Spectrum DX - Advice Needed on Neck and Bridge Replacement
» ...and the Genesis I that became a project as well.
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|